Focal Point Centrurion 30, Инструкция по установке, обслуживанию и эксплуатации

Страница: 9 / 21

IIN NSSTTAALLLLAATTIIO ON N M MEETTH HO OD D 33 ((ttiim mbbeerr ffrraam meedd bbuuiillddiinnggss))
Where removal of any part of a timber frame is undertaken the structural integrity of the wall must be
retained. The advice of your local building control officer should be sought. If the property is under any NHBC
warranty it is also advised that their advice on this kind of modification is sought.
Either of the two preceding installation methods may be adapted for timber framed buildings, providing extra
care is taken in ensuring combustible materials are adequately protected from the effects of heat.
The appliance must be installed in accordance with the British Gas documents DM2 and DM3 or the Institute
of Gas Engineers published procedure document IGE/UP/7.
Special attention must be paid to the location of studwork frames of the inner leaf and the appliance posi-
tioned accordingly. Wires and pipes that run within the wall must also be taken into account.
I Innssttaallllaattiioonn aass ppeerr m meetthhoodd 11 ((aaggaaiinnsstt iinnnneerr w waallll))
When using this method of installation the following amendments should be incorporated.
50mm insulation (e.g. rockwool) plus a 12 mm thick fire retardant board, 'Superlux' or equivalent, must be pro-
vided between combustible materials and the sides and rear of the cavity box. 100 mm of insulation (e.g. rock-
wool) plus a 12 mm thick fire retardant board, 'Superlux' or equivalent, must be provided to the top of the cav-
ity box. It is also a good idea to enable as much airflow into and out of the area behind the fire as possible
without excessive heat losses when the fire is off.
7 7
Superlux Box: External Dims;
Height 670mm, Width
529mm, Depth 207mm
Outer Cavity Leaf
Rockwool Insulation 50mm
sides and rear 100mm top
Inner Cavity Leaf
Non-combustible
Backpanel
Cavity Box
66..55
Superimposed Hearth