FMT Swiss AG 23295, Руководство по эксплуатации

Страница: 4 / 24

4
G
Operating instructions for turbine flow meter
1.2.1 Display LCD
The meter‘s LCD display is equipped with two numeric registers and different types of display modes
showing information to the user only when it is actually needed with the operation / function going on
at the moment.
Key:
Register of partial volume (5 digits with floating decimal: 0.000+99999) showing the amount of liquid 1.
that has been delivered since the RESET button was last pressed
Battery charge
2.
Display of the calibration mode 3.
Register of total volume (6 digits with floating decimal 0.0-999999x10/x100) showing two different 4.
kinds of total volumes:
4.1 Non-resettable total volume (TOTAL)
4.2 Resettable total volume (RESET TOTAL)
Total volume multiplication factor (x10/x100)
5.
Type of total volume display (TOTAL / RESET TOTAL) 6.
Units for total volume: L = litres, GAL = gallons 7.
Flow rate 8.
Display of measuring unit for partial volumes: 9.
QTS = quarters; PTS = pints; L = litres; GAL = gallons;
The display can be adapted to the direction of flow in 90° steps. To do so, loosen the four screws (item
1). Now you can mount the display unit turned 90°.
Caution!
O-ring (item 10) must be re-mounted correctly.
■ ■
Do not pinch or excessively twist the cables from the battery compartment (item 11) to the
■ ■
PCB (item 14).
Then re-insert and tighten the screws (item 1).
1.2.2 User controls
There are two push buttons on the meter (RESET and TOTAL), each controlling two main functions
(pressed individually) and various auxiliary sub-functions (pressed simultaneously).
Main functions:
RESET button: Resetting the partial volume register and the (resettable) total volume register RESET
■ ■
TOTAL.
TOTAL button: Calling up the calibration mode. Pressed together, the two buttons call up the
■ ■
configuration mode where you select the unit of measurement.