FMSRZ101
FMSRZ102
FMSRZ103
FMSRZ104
FMSRZ105
FMSRZ106
FMSRZ107
FMSRZ108
FMSRZ109
FMSRZ110
FMSRZ111
FMSRZ112
FMSRZ113
FMSRZ114
FMSRZ115
FMSRZ116
Fuselage
Main Wing Set
Horizontal Stabilizer
Vertical Stabilizer
Cockpit
Cowl
Front Landing Gear Door
Main Landing Gear Door
Linkage Rod
Wheel Set
Pipe
Screw Set
Control Horns
Rocket set
Pilot
Decal Sheet
LED
Front Landing Gear Set
Main Landing Gear Set
Main Landing Gear System
Front Landing Gear System
EL-Retract
EL-Retract*2
EL-Retract
80A ESC
3060-KV1900 inner runner motor
Predator 13g digital metal gear servo positive
Predator 13g digital metal gear servo reverse
9g digital metal gear servo positive
9g digital metal gear servo reverse
FMSRZ117
FMSRZ118
FMSRZ119
FMSRZ120
FMSRZ121
FMSREX052
FMSREX053
FMSREX054
PRESC032
PRKVX1900-1
PRSER004
PRSER005
FMSSER015
FMSSER016
Trouble shooting
Problem
Possible Cause
Solution
Aircraft will not respond to
the throttlebut responds to
other controls.
-ESC is not armed.
-Throttle channel is reversed.
-Lower throttle stick and throttle trim to lowest settings.
-Reverse throttle channel on transmitter.
Extra propeller noise or
extra vibration.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Replace damaged parts.
-Tighten parts for propeller adapter, propeller and spinner.
-Remove and install propeller correctly.
Reduced flight time or
aircraft underpowered.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Completely recharge flight battery.
-Replace flight battery and follow flight battery
instructions.
Control surface does not
move, or is slow to respond
to control inputs.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
-Replace or repair damaged parts and adjust controls.
-Do a check of connections for loose wiring.
Controls reversed.
Channels are reversed in the
transmitter.
Do the control direction test and adjust controls for
aircraft and transmitter.
-Motor loses power
-Motor power pulses then
motor loses power.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low Voltage
Cutoff(LVC).
-Do a check of batteries, transmitter, receiver, ESC, motor
and wiring for damage(replace as needed).
-Land aircraft immediately and recharge flight battery.
LED on receiver flashes
slowly.
Power loss to receiver.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
Spare parts list content
Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the
stock ESC instruction manual.
13
