FMS BKS600A, Руководство по эксплуатации

Страница: 46 / 48

Operating Manual BKS600A
46
15 Trouble Shooting
Error Cause Corrective action
Controller guides web
edge immediately out
of the sensor Control mode wrong
parametrized Set parameter Control mode according to the
sensor position
Parameter Output config. is
set wrong
Change parameter Output config.
Sensor signal wrong
parametrized Set servcie parameters Sensor covered, Sensor
uncovered, Sensor range correct
No edge found
Edge missing The sensor is not adjusted
properly Adjust sensor more accurate
Steering frame does
not move No signal; sensor not
correctly connected Connect sensor correctly according to wiring
diagram and installation guide
No signal; cable break Replace cable or send sensor to FMS
No signal; sensor defect Send sensor to FMS; use other sensor
Steering device not correctly
connected Connect steering device correctly according to
wiring diagram and installation guide
Steering device moves
in the wrong direction Service parameter Motor
config. is set wrong
Change service parameter motor config.
Sensor signal wrong
parametrized Set servcie parameters Sensor covered, Sensor
uncovered, Sensor range correct
Motors of the linear
units don’t move Motors are not correctly
connected Connect motors correctly referring to wiring
table
Hardware defect Contact FMS customer service
Linear units don’t
move properly to its
reference positions
Limit switches are connected
wrong Connect limit switches correctly referring to
wiring diagram
Display shows
not determinable
A function can’t be
performed at that time (i.e.
wiring error) Check wiring, parametrization and overall
system shape
Dig. outputs do not
work
Wiring error Check wiring of the dig. outputs (ref. to
wiring diagram)
Grounding not connected Connect Grounding wire to the PE terminal
(re. to wiring diagram)
C.n HW error
Hardware of channel n defect Contact FMS customer service
Subprint of channel n is not
detected Check if subprints are seated correctly (ref. to
„14.1 Additional Setting Elements“)
Contact FMS customer service