www.fmiproducts.com
116237-01M
25
Removing Glass Door
If replacement of glass is necessary, the
entire assembly, glass and frame, must be
replaced. If glass is broken, wear gloves and
tape remaining fragments onto frame.
1. Remove screen assembly by pushing
the rod either left or right, then down and
forward to remove screen/rod assembly
from firebox. Set assembly aside.
2. Lift up on latches to unlock. There are two
on top of firebox and two below firebox that
hold glass door in place (see Figure 38).
3. While holding glass door to prevent it from
falling and causing injury, remove five
screws from hinge located on left side of
door frame assembly (see Figure 38).
Lock
Unlock
Glass Frame
Assembly
Screw
Figure 38 - Removing/Replacing Glass
Door
Hinge
Latch
4. Remount new frame at hinge with five
new screws before closing door. This will
ensure seating of gasket.
5. Close glass door frame. Lock latches by
placing bar under tab on door and pushing
down and back on latch (see Figure 38).
6. Replace screen/rod assembly by revers
-
ing step 1.
7. Replace louvers by reversing procedure
under
Removing Louver Panels,
page 24
(VC42 Series).
8. Replace screen door assembly, see remov
-
ing screen door assembly, see Figure 37
page 24, (VCC42 series).
Cleaning Glass Door
See
Cleaning and Maintenance
on page 30.
FIREPLACE
INSTALLATION
Continued
INSTALLING LAVA ROCK AND
GLOWING EMBERS
It is very important to keep logs exactly as
installed. Do not modify logs. Only use log
set designed for this fireplace. Logs under
log/grate assembly are attached to burner.
Do not attempt to move these logs as this
will damage logs.
WARNING: Logs are unitized
and attached to the grate. Do not
handle log/grate assembly by
logs. Always pick up by grate.
Open louvers, remove screen, unlock door
latches and open glass door. See
Removing
Glass Door
, steps 1 and 2, page 24.
1. Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely and sparingly directly onto exposed
front section of burner (see Figure 39). This
will create the glowing ember appearance
as flame touches ember material. Do not
block air slots by using too much ember
material in one area.
Place small pieces of
ember material up to the pilot and cover all
pilot ports. It is not necessary to use all of
the ember material provided
.
2. Pour lava rock onto plenum but not onto
flat burner. It is not necessary to use all
of the lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
3. Close glass door, lock door latches, replace
screen and close louvers (see
Removing
Glass Door
, steps 5 through 7).
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
Figure 39 - Placing Ember Material on Burner
Plenum
Ember Material
Place embers all the
way up to the pilot