www.fmiproducts.com
125566-01C
21
INSTALLATION
Continued
7
Figure 34- Installing Log # 7
8
Figure 35- Installing Log # 8
Figure 36- Final Assembly
LTF(18,24,30)-MM LOG PLACEMENT
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater or as identified for use
with the heater as shown in Figure 20, page
17. Each log includes reference numbers
formed in the bottom or back of the log. The
circled number indicates the order it is placed
on the burner system. The remaining numbers
indicate the size burner system the logs are
designed to fit. For example, the first log for
a 24 inch burner system will include a circled
1 and also a 24. The circled 1 indicates this
is the first log to be installed. The 24 indicates
this log belongs to a 24 inch log set.
See page
42 for reference numbers detail.
1. Place the rear log (#1) on base assembly
as shown in Figure 37. Log will fit over
right end of burner and rest in middle
of U-burner.
1
Figure 37 - Installing Log # 1
''U'' -
Burner
Base
assembly
1. Place the middle log (#2) in front of the
U-burner and against the edges of the
plate as shown in Figure 38, page 22.
2. Place the front left log (#3) onto the base
assembly between the middle log (#2)
and the grate fingers. The back of the
front left log (#3) will rest against the front
of the middle log (#2). The notch at the
end of the front left log (#3) will fit around
the grate bar. See Figure 39, page 22.
3. Place the front right log (#4) onto the
base assembly between the middle log
(#2) and the grate. The back of the front
right log (#4) will rest against the front of
the middle log (#2). The notch in the end
of the front right log (#4) will fit around
the grate bar. See Figure 40, page 22.
