FMI PTW72, Руководство пользователя, Страница: 9 / 335

Franklin Tack Station
a. E-STOP/CONTROL POWER - Removes and restores power to all control
functions of the machine. Pulling UP fully on the button will start the
hydraulic unit and enable all functions of the machine. Push in on the
button to stop the hydraulics and disable all machine functions.
b. DATUM SIDE MAG-CON-REV/FWD- Allows movement of the magnet
rollers forward and reverse. Use to position the flange closest to the
operator once it has been placed on end.
c. DATUM SIDE FLANGE UPENDERS- UP/DOWN- Switch to UP to bring
the flange on the datum side up on it’s end.
d. FLANGE UPENDERS-1 IN/OUT- Use to position the flange upender
assemblies on the first conveyor. Allows positioning of the flange across
the conveyor.
e. STOP GATE Down/Up - Turn switch to control Stop Gate position.
f. OUTFEED CONVEYOR; INFEED CONVEYOR; On/Off - Each selector
switch controls the power to the appropriate conveyor drive. Used to jog
the conveyors that are selected to run.
g. CONVEYORS REV/FWD – Place switch in FWD to move conveyors in the
forward direction. REV moves conveyors in the reverse direction.
h. CONVEYOR SPEED- LOW/MED/HIGH- Use to select between three
ranges of conveyor speeds. Conveyors will travel at the slowest rate when
LOW is selected.
i. ALL CONVEYORS FORWARD —Use to jog all conveyors forward
simultaneously.
j. WEB LIFT Down/Up - Turn switch to control Web Lift position.
k. FLANGE CLAMP-CLOSE-OPEN —Use to open and close the flange
clamp.
l. FLANGE UPENDERS-2 IN/OUT- Use to position the flange upender
assemblies on the second conveyor. Allows positioning of the flange across
the conveyor.
m. OPOSITE DATUM SIDE FLANGE UPENDERS- UP/DOWN- Switch to
UP to bring the flange opposite the datum side up on it’s end.
n. OPOSITE DATUM SIDE MAG-CON-REV/FWD- Allows movement of the
magnet rollers forward and reverse. Use to position the flange opposite the
operator once it has been placed on end.
o. BEAM CLAMP- OUT/IN- Closes and opens the beam clamp. Use to clamp
front of beam in preparation for welding.
p. MAGNET- OFF/ON- Select ON to turn on the web magnets. Use to pull
down and hold the web, once positioned, in preparation for welding.
q. Tack\PTW - Place switch in Tack position to allow operation of the outfeed
conveyor from the tack station control panel. Placing switch in PTW position
4