125626-01A
2
Figure 4: Removing knockout and
Figure 6: Wiring Diagram For Blower
Accessory
Figure 5: Front of Heater, Attaching
blower
ﱩȨ
»
Ë°°»®
»
̸»®³±-¬¿¬
Í»²-±®
Í©·¬½¸
Ù®»»²
ɸ·¬»
Ù®»»²
ɸ·¬»
ïïðñïïë
ÊòßòÝò
Þ´±©»®
Ó±¬±®
Þ´¿½µ
Þ´¿½µ
ͽ®»©-
б©»® ݱ®¼ д¿½»³»²¬
Þ´±©»®
Í´±¬-
Þ´±©»®
Ñ«¬´»¬
Þ¿½µ
п²»´
»
Ú¿²
Í©·¬½¸
ATTACHING BLOWER ACCESSORY
Continued
Position blower assembly on cabinet back
8.
While holding blower against inside of
9.
10.
Reattach front panel to heater using four
11.
painted screws removed in step 1.
Complete installation of heater by follow-
12.
ing the steps in your owner's manual.
WALL MOUNTING
INSTRUCTIONS FOR
MODELS WITH MOUNTING
BRACKETS
Mount heater to wall by following steps
1.
under
Installing to wall
in owner's
manual.
Plug power cord of blower into grounded
2.
outlet.
EXTENSION CORD
Use extension cord if needed. The cord must
three-hole receptacle. Make sure cord is in
good shape. It must be heavy enough to carry
the current needed. An undersize cord will
cause a drop in line voltage. This will result in
loss of power and overheating. Use a No. 16
AWG cord for lengths less than 50 feet.
CAUTION: Verify proper op-
eration after servicing.
BLOWER OPERATING
The blower is connected to a thermostat. When
blower will shut off. Blower will cycle on and
off in this manner. Note: If you have a heater
not turn off and on at exactly the same time.
Blower cycle times will vary with heat setting
selected.
Old Upper
www.tesstools.net
800 397 7553
