www.fmiproducts.com
100448-01F
3
17" Min.
Fireplace
Cross
Section
Mounting Brass Hood On Fireplace
Surface
Fireplace
Cross
Section
Figure 10 - Hood Placement for Masonry
Fireplace
Hood
Mounting
Brackets
3. Remove mounting brackets and drill a 5/32
inch diameter hole into fireplace lintel at
each marked location.
4. Use the masonry screws provided to fasten
brackets to lintel (see Figure 9, page 2).
5. Slide hood over mounting brackets (see
Figure 10).
Figure 11 - Installing Brass-Plated Hood
Mounting Brass Hood Inside
Fireplace Opening
Figure 12 - Installing Hood Above
Opening on Manufactured Fireplace
INSTALLING HOOD ABOVE
MANUFACTURED FIREPLACE
OPENING
1. Cut mounting bracket off at point "A" (see
Figure 6, page 2).
2. Tape mounting bracket to fireplace hous
-
ing. Make sure top of bracket is six inches
above fireplace opening (see Figure 12).
3. Mark screw locations through slots in
mounting bracket.
21'' Minimum Fireplace Opening Required
to Maintain 17'' Minimum from Bottom of
Hood to Bottom of Fireplace
Brass Fireplace
Hood
Brass Fireplace
Hood
Fireplace
Fireplace
6"
INSTALLING HOOD TO
MANUFACTURED FIREPLACE
WARNING: Many manufactured
fireplaces have louver openings
for ventilation. Do not cover any
louver openings with fireplace
hood. Do not mount fireplace hood
above any louver openings. Only
mount fireplace hood below louver
openings. Covering louver open-
ings or mounting fireplace hood
above louver openings will cause
the fireplace to overheat and could
cause property damage, personal
injury, or death due to fire.
CAUTION: Brass-plated hood
may tarnish due to heat if you
mount it too low. Make sure the
bottom of hood is at least 17 inches
above the bottom of fireplace (see
Figure 11). If installation height
is less than 17 inches, use the
GA6050 flat-black hood.
You may need to alter or discard the mounting
brackets to install the fireplace hood to the
manufactured fireplace.
Mounting
Brackets
Manufactured
Fireplace
Fireplace Opening
