www.fmiproducts.com
100448-01F
4
100448-01
Rev. F
11/11
2701 S. Harbor Blvd.
Santa Ana, CA 92704
1-866-328-4537
www.fmiproducts.com
Figure 13 - Installing Hood into Opening
of Manufactured Fireplace
Figure 14 - Screw Placement
If you have any questions, contact:
Fireplace
Opening
Approximate Screw
Locations
Fireplace
Cross
Section
Fireplace
Opening
4. Remove mounting brackets and drill a 1/8
inch diameter hole into fireplace housing
at each marked location.
5. Use the sheet metal screws provided to
fasten brackets to fireplace housing (see
Figure 12, page 3).
6. Slide hood over mounting brackets (see
Figure 12, page 3).
INSTALLING INTO MANUFACTURED
FIREPLACE OPENING
1. Discard the mounting brackets.
2. Place the hood inside the fireplace opening
as shown in Figure 13.
3. Hold the hood in place and drill four holes
through hood and into channel on the fire
-
place opening (see Figures 14). Make sure
holes are evenly spaced and cover most of
the hoodʼs length.
4. Use the sheet metal screws provided to
fasten the hood to the fireplace opening.
Manufactured
Fireplace
Manufactured Fireplace
Manufactured
Fireplace
Fireplace
Hood
Fireplace Opening
OPERATING FIREPLACE WITH
FIREPLACE HOOD
WARNING: Fireplace hood
becomes very hot during fire
-
place operation. Do not touch
fireplace hood. Severe burns
could occur.
IMPORTANT:
Remove all tape used
when installing fireplace hood before
operating fireplace.
