3
105224
OWNER’S MANUAL
AUT
O
MAN
OFF
ST
ATUS
ON
LO
HI
TEMP
PRODUCT
IDENTIFICATION
LOCAL CODES
Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note:
Where listed vented decorative logs
are required, thermostat operation is not
permitted.
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no
outside venting. There is no heat loss out a vent
or up a chimney. Heat is generated by realistic,
dancing yellow flames. This heater is de-
signed for vent-free operation with flue damper
closed. It has been tested and approved to
ANS Z21.11.2 standards for unvented heat-
ers. State and local codes in some areas pro-
hibit the use of vent-free heaters. This heater
may also be operated as a vented decorative
(ANS Z21.60) product by opening the flue
damper (non-thermostat operation only).
APPLICATION
These multisided logs are designed to be
equally beautiful when viewed from any angle.
They are designed specifically for use in
see-through, peninsula, and island fireboxes
with multiple openings. You may also in-
stall this log heater in a standard firebox.
SAFETY PILOT
This heater has a pilot with an Oxygen
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
UNPACKING
CAUTION: Do not remove the
metal data plates from the grate
assembly. The data plates contain
important product information.
1.
Remove logs and heater base assem-
bly from carton.
Note:
Do not pick up
heater base assembly by the burner.
This could damage heater. Always
handle base assembly by grate.
2.
Remove all protective packaging ap-
plied to logs and heater for shipment.
3.
Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.
Figure 1 - Product Identification
Control Knob
Piezo
Ignitor
Log Set
Base Assembly
Optional
Remote
Control
Flame
Adjustment
Knob
Optional Remote
Selector Switch
REMOTE CONTROL
ACCESSORIES
There are four optional remote controls that
can be purchased separately for this log
heater
• Wall switch
• Wall thermostat
• Hand-held ON/OFF remote
• Hand-held thermostat remote
See Accessories, page 21.
The wall thermostat or hand-held thermo-
stat may not be used where vented decora-
tive listing is required.
