FLYSURFER Infinity 2.0 Bar, Руководство по эксплуатации

Страница: 21 / 47

EN
41
03
MA
IN
T
EN
A
N
C
E
EN
40
Sort and lay out your flying lines.
Unloop the steel ring from the Endline.
Pull the Endline out of the Quick
Release and guidance-block. Unloop
the Endline from the fifth line or the
front line (depending on kite model).
Attach the new Endline. Loop
it to (depending on kite model) the
FDS or appropriate front line.
There is a thin white line attached
above the Adjuster. Use this to thread
the endline through the guidance-block.
Thread the endline through the D-
Ring of the adjuster and then through
one of the holes of the eyelet.
Use the thin white line (or a
piece or bridle replacement line
from the repair kit) to help you
thread the Endline through the
middle hole of the Quick Release.
Depower Line
Attention : Replace the
Depower Line in time, as
soon as it start to be stron-
gly frayed. Do not wait for
the Depower Line to break.
Open the bowline knot under the
Adjuster and remove the Depower Line.
Thread the new Depower Line
through both holes of the metal bridge
of the Infinity 2.0 Quick Release.
Thread one end at a time through
a different hole in the eyelet.
Thread both ends through the
Stopper Ball and the short piece of
tubing on the bottom of the adjuster.
Secure the Depower Line with a
bowline knot and adjust the depower
throw to either the original or your
preferred length. Pull the knot pro-
perly tight and then check the trim.
Endline
The Endline should be replaced when
necessary, or else the Endline can
break and the kite can blow away after
leashing out and endanger others.
Depending on kite model the Infinity
2.0 Bar is fitted with a Front Line
Safety (FLS - Speed 3, Speed 4) or the
Full Depower Safety (FDS - Psycho4,
Unity). Refer to the differences when
replacing the FLS or FDS endlines.