Flying Tech G-Force250, Руководство по эксплуатации

Страница: 4 / 17

4. Attach one motor to each arm using the
shorter screws that come in the power pack.
5. Apply heat shrink to the three wires leading
back from each motor.
6. Stick the two foam pads onto the underside
of the PDB, noting their approximate position.
7. Stick the 4 ESCs onto the foam pads so that
their black wires point towards each other.
8. Remove the plugs leading from the twisted black/white wires on each ESC, then solder the
white wire to its local signal connection (S1-S4) and the black wire to the nearby ground
connection. Next shorten the red/black power wires and solder them to the ESC power
connections, note that the positive connection is labeled on the topside of the PDB.
9. Attach the short M3 spacers to the underside of the PDB (four for each motor arm), using the
M3x4mm button head screws and a washer for each along with a drop of thread lock.