FLYGT FPC100, Инструкция по установке и эксплуатации

Страница: 14 / 28

The stop level can be set in two ways:
1. Pressing AUTOSET at pumping without snoring sets the stop level as a percentage
below the full load power, see Complete set-up at pumping (without snoring) (page
12).
2. Pressing AUTOSET at snoring sets the stop level as a percentage above the snore
power, see
Complete set-up at snoring
(page 13).
In event of an alarm during the set-up, see PROTECTION AND ALARM (page 19).
Pump power
Manually set power level
Full load power
Stop level
“Snore power”
Time
Stop at underpower
Complete set-up at pumping (without snoring)
1. Install FPC100 according to INSTALLATION (page 5).
2. Set the Hand-0-Auto switch in the 0-position and turn on the supply voltage to
FPC100.
3. If a padlock ( ) is shown on the display, viewing and changing of parameters are
locked. Set window 09 to 369 and confirm with ENTER to remove the padlock and
get access to parameter settings (windows 11- 99).
4. Clear the present stop level by pressing AUTOSET until “SEt” is shown on the display.
The stop level is hence set to 0 % since the pump is off.
5. Set window 13 to ( – ) and confirm with ENTER. FPC100 is now prepared for Auto-set
at pumping without snoring.
6. Set the Hand-0-Auto switch in the Auto-position to start the pump. If necessary, press
START/RESET.
7. Make sure that the pump is working steadily. Press AUTOSET until “SEt” is shown on
the display.
The stop level (window 11) is now set in relation to the measured power (window 04) and
the snore margin (window 12).
Further adjustments can be done according to
Adjustment of the stop level
(page 14)—
Window parameters
(page 15).
Example:
Stop level (window 11) = Measured full load power (window 04) - Snore margin (window
12)
The pump is pumping water at the measured full load power 68 %. The snore margin is set
to 10 %. Pressing AUTOSET will then give the stop level 58 %.
DETAILED SETTINGS
12 Single pump controller Installation and user manual for FPC100