6 – Application – Cockpit
ELIOS 2 USER MANUAL
Page 70 of 106
power during flight and crash even if still charged at a good level. Arming
is impossible in this situation for safety reasons.
Replace the battery before flight.
If you are in a cold environment such as during winter, the battery can be
faulty due to the low temperature, although in good condition. Replace the
battery with one at a normal ambient temperature (typically 10°C to 30°C).
One possibility to keep batteries warm is by using a special LiPo-safe bag
with built-in electric warmer. Please refer to the battery safety guidelines
for more information.
Please refer to the Elios 1 instructions for more information about battery
handling specifics.
Log SD card error
Either the SD card used for log recording is faulty, or the aircraft has
stopped recording log files. If this message persists, the current SD card can
be damaged; this can be checked easily by using a different SD card.
Camera SD card error
Error concerning camera SD card operation. Can be caused by a corrupt
card.
Manual thrust engaged. Move
switch down before arming
and for altitude hold
The altitude control lever is in the thrust position. Dismiss this warning if
you are comfortable flying in this advanced mode, or switch to altitude hold
mode instead. The drone will not arm in this mode.
Service overdue by __ s -
Warranty may be void
The service of the aircraft is overdue. Please contact Flyability.
Thermal camera error -
Restart robot
The thermal camera cannot record at the moment. Restart the robot to
restore recording. If the issue persists, please contact support.
Manual transmission channel
set. Use auto if quality is low.
Radio transmission channel choice is set to manual on the current aircraft,
likely during a previous flight. This is a reminder of this setting since manual
channel choice can decrease the video quality in comparison with the
automatic mode. Onboard video recording quality is not affected by this.
You can safely fly with the current transmission setting. If video quality is
low at some point, you can set the channel choice mode to automatic to
attempt to get better quality.
SD card slow for logs -
Possible loss of data
The inserted SD is not able to write fast enough. User may try to reformat it
according to the aircraft user manual or contact Flyability.
Propulsion system failure
Failure detected in the aircraft propulsion system.
Check that propellers are in good condition, tightly attached to the motors
and each one is mounted to a motor with the correct direction of rotation.
A propeller may be broken, loose, or in the wrong place;
This can also signal a motor failure. If you are confident with the proper
tightening of propellers and correct state of motors, Try arming the arcraft
again
Camera error
The camera is encountering a problem that can affect the recording. Also
caused by old camera firmware version; consider upgrading the camera
firmware especially after an aircraft firmware upgrade.
Stability sensor unresponsive -
Poor ASSIST stability
expected.
One of the arm vision and distance sensor is damaged or not functioning
correctly. If restarting the aircraft does not fix the issue, change the sensor,
or contact Flyability. Access the maintenance tab in cockpit for further
diagnosis.
Tablet temperature high
The internal components of the tablet on which Cockpit is running are
hotter than during operation in normal conditions. It is likely that an