FLY SP-770, Как в инструкции

Страница: 26 / 77

3.5.3 Reset
The MT6305 contains a reset circuit that is active at both power-up and power-down.
The RESET pin is held low at initial power-up, and the reset delay timer is started. The
delay is set by an external capacitor on RSTCAP:
(1) At power-off, RESET will be kept low.
3.5.4 Over temperature Protection
If the die temperature of MT6305 exceeds 165°C, the MT6305 will disable all the
LDOs except the RTC LDO. Once the over temperature state is resolved, a new power
on sequence is required to enable the LDOs.
3.5.5 Battery Charger
The MT6305 battery charger can be used with Li-ion and NiMH batteries. BATUSE
pin can set MT6305 to fit the battery type. When BATUSE is set low, Li-ion battery is
used. When BATUSE is set high, then NiMH battery is used. MT6305 charges the
battery in three phases: pre-charging, constant current mode charging, and constant
voltage mode charging. Figure 2 shows the flow chart of charger behavior. The
circuitry of MT6305 combines with a PMOS transistor, diode, current-sense resistor
externally to form a simple and low cost linear charger shown in Figure 4. MT6305 is
available pulsed top-off charging algorithm by the CHRCNTL pin control from
baseband chipset.