Fluo FSS 241 EI/JDF-N3, Руководство пользователя

Страница: 9 / 33

7
● During operation, point the remote control signal sender at the receiving window on indoor unit.
● The distance between signal sender and receiving window should be no more than 8m, and there
should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don’t use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there’s no display, please replace batteries.
NOTE:
Operation guide
1. Press the back side of remote controller marked
with "
", as shown in the fig, and then push out
the cover of battery box along the arrow direction.
2. Installation two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar are
correct.
3. Reinstall the cover of battery box.
Installation batteries
Operation guide
1. After connecting the power, press " " button on remote controller to turn on the air
conditioner.
2. Press "MODE" button to select your required mode: Auto, Cool, Dry, Fan, Heat.
3. Press " " or " " button to set your required temperature. (Temperature can’t be
adjusted under auto mode).
4. Press "FAN" button to set your required fan speed: auto , quiet , fan1, fan2 , fan3 , fan4 ,
fan5 , stepless speed.
5. Press "SWING" button to turn on or turn off the swing function.
ὐ
ὑ
ὒ