Fluke U1500s Скачать руководство пользователя страница 3

Instructions

Table 

2

 shows the Product. To use the Product:

1.

Connect the input and output test leads to the Product (see 

and 

in Table 

2

). 

2.

Connect the output test lead (BNC to Banana cable) to the power 
analyzer, oscilloscope, or other instruments.

3.

Set proper scale for the power analyzer or other instruments, and 
adjust the sensitivity based on the tested voltage.

4.

Turn on the Product 

The power indicator light (see 

Table 

2

) flashes green. If the 

battery light flashes red, change the batteries. 

5.

Connect the input test lead to the DUT (Device Under Test) and 
start the test. 
Keep the Product away from high-voltage pulse circuits to reduce 
interference to the Product while testing.

6.

Disconnect the test leads from the DUT, and turn off the Product 
after test completion, then unplug the test leads.

Conforms to relevant Australian Safety and EMC standards.

Conforms to relevant South Korean EMC Standards.

Measurement Category III is applicable to test and measuring 
circuits connected to the distribution part of the building’s low-
voltage MAINS installation.

Measurement Category IV is applicable to test and measuring 
circuits connected at the source of the building’s low-voltage 
MAINS installation.

~

This product complies with the WEEE Directive marking 
requirements. The affixed label indicates that you must not 
discard this electrical/electronic product in domestic household 
waste. Product Category: With reference to the equipment types 
in the WEEE Directive Annex I, this product is classed as 
category 9 "Monitoring and Control Instrumentation" product. Do 
not dispose of this product as unsorted municipal waste.

Table 1. Symbols (continued)

Symbol

Definition

Содержание U1500s









Отзывы: