Ti200, Ti300, Ti400
Users Manual
42
Battery Care
Warning
To prevent personal injury and for safe operation of the Product:
•
Do not put battery cells and battery packs near heat or fire. Do not
put in sunlight.
•
Do not disassemble or crush battery cells and battery packs.
•
Remove batteries to prevent battery leakage and damage to the
Product if it is not used for an extended period.
•
Connect the battery charger to the mains power outlet before the
charger.
•
Use only Fluke approved power adapters to charge the battery.
•
Keep cells and battery packs clean and dry. Clean dirty
connectors with a dry, clean cloth.
Caution
To prevent damage, do not expose Product to heat sources or
high-temperature environments such as an unattended vehicle in
the sun.
To get the best performance from the lithium-ion battery, use the guidelines that
follow:
•
Do not store the Imager on the charger for more than 24 hours as reduced
battery life may result.
•
Charge the Imager for a two-hour minimum at six-month intervals for
maximum battery life. Without use, the battery will self-discharge in
approximately six months. Batteries stored for long periods will need two to
ten charging cycles for full capacity.
•
Always operate in the specified temperature range.
•
Do not store the batteries in extreme cold environments.
•
Do not attempt to charge the batteries in extreme cold environments.
Caution
Do not incinerate the Product and/or battery. Go to Fluke’s
website for recycling information.