Fluke DTX-1800, Техническое справочное руководство, Страница: 51 / 398

Getting Acquainted
Basic Features
1-25
1
Checking the Hardware and Software
Versions
To see information about the tester’s hardware and
software, the test limits and cable types databases, and the
Autotest counts for attached link adapters:
1 Connect the tester and smart remote through
adapters, as in Figure 1-10.
2 Turn the rotary switch to SPECIAL FUNCTIONS.
3 Use
D
to highlight Version Information; then
press
H
.
4 Use the softkeys to switch among information screens
for the tester, remote, and any modules or adapters
attached.
Information for link adapters includes the number of
Autotests run with the adapter:
•
Autotest Count is the total number of tests run
with the adapter.
•
Current Series is a counter you can reset.
To reset the Current Series counter, use the softkeys to
access the link adapter’s Version screen; then press
H
.
To determine if your tester needs a software update, visit
the Fluke Networks website to see if an update is available.
See Chapter 14 for details on updating the tester's
software.
The Main Autotest Screen
The Autotest automatically runs all the tests necessary to
certify that cabling meets the requirements of the selected
test limit. You will probably use the Autotest more than any
other of the tester’s functions.
When you first turn the rotary switch to AUTOTEST, the
main Autotest screen shows settings you should check
before you start testing. Figure 1-11 describes this screen.
You can change these settings in SETUP, as described in
Chapters 2, 3, 5, 7, and 8.