Fluke DTX-1800, Техническое справочное руководство

Страница: 250 / 398

DTX Series CableAnalyzer
Technical Reference Handbook
8-42
Testing Your Test Reference Cords in Far End
Source Mode
W
Caution
If you disconnected the test reference cord from
the tester’s output, you must set the reference
again to ensure valid measurements.
11 Disconnect the test reference cord from the INPUT port
on the tester.
12 Make the connections shown in Figure 8-20.
13 Turn the rotary switch to AUTOTEST, then press
P
.
14 Press
H
to see the test result. The result must be no
more than these limits:
W
Caution
An overall result of PASS does not show that
the test reference cords are good. You must
compare the loss to the limits given here to
make sure the cords are good.
Multimode test reference cord:
850 nm: 0.11 dB or less
1300 nm: 0.10 dB or less
(The limits are different because fiber has more loss at
850 nm than at 1300 nm.)
Singlemode test reference cord:
0.20 dB or less for 1310 nm and 1550 nm
15 If a result is more than the limit shown above, use the
procedure given in Appendix A to test the cords. When
you have good test reference cords, set the reference
and do these steps (11 through 15) again before you
test a fiber link.
16 Save the test results to show that you used good test
reference cords to test the link.
Note
Fluke Networks recommends that you use this
procedure to make sure your test reference cords
are good before you test each fiber link.