Precision Infrared Calibrator
Safety Information
3
Electrical Hazard
Follow these guidelines closely to make sure that the safety mechanisms in this Product operate
properly. This Product must be plugged into an AC-only outlet according to the
. The power cord of the Product has a three-pronged grounding plug for your
protection against electrical shock. Plug the power cord directly into a properly grounded three-prong
receptacle. The receptacle must be installed in accordance with local codes and ordinances. Consult a
qualified electrician.
Warning
To prevent personal injury:
•
Always carry the Product in an upright position. The convenient pull-up handle allows
one hand carrying.
•
Do not operate the Product in excessively wet, oily, dusty, or dirty environments.
•
Do not operate near flammable materials.
Caution
To prevent damage to the Product:
•
Do not use an extension cord or adapter plug.
•
Do not operate the Product without a properly grounded, properly polarized power
cord.
•
Do not connect the Product to a non-grounded outlet.
•
For installations with polarized outlets, ensure that the polarity of the connection is
correct.
•
HIGH VOLTAGE is used in the operation of this equipment. Contact an Authorized
Service Center (see
) for service from a qualified technician.
No user serviceable parts.
•
Always replace the fuse with one of the same rating, voltage, and type.
•
Always replace the power cord with an approved cord of the correct rating and type.
•
Protect the target against dirt and damage - scrapes and scratches. A well kept target
surface, free from dirt and damage, produces better measurements. Use the target
cover whenever the Product is not in use to protect the target. Always use the target
cover when transporting the Product, but remember to never transport the Product at
high temperatures.
•
Do not touch the target. Oils and salts from the skin will permanently damage the
target surface at high temperatures.
•
Do not use fluids to clean the target surface.
•
Do not use shop air to clean the target surface. Oil and contaminants in the shop air
could contaminate the surface.
•
Do not use canned, compressed air (used to clean a computer) to clean the target
surface. Chemicals in the air could contaminate the target surface.
