Fluke Calibration 7526A, Начало работы

Страница: 17 / 30

Precision Process Calibrator
Product Description
9

Function Keys

For all but Thermocouple output modes, toggle between
Standby and Operate modes. In Standby mode, changes to
the output value in the display is not applied to the terminals
until you select the Operate mode. In Operate mode, each
change to the output value in the display is applied to the
terminals immediately. Voltages more than 30 V are not
applied to the terminals and the mode automatically reverts
to Standby for your safety.
E
Changes the Product output or parameter to the numeric
value typed into the keypad.
 Erases a partial keypad entry and reverts the Product output
or parameter to its last known value.

Prepares for selection of a secondary function with the
numeric keypad. The secondary function is shown above
each numeric key. The display changes to SHIFT ENABLED
until a numeric key is pushed. To cancel the selection, push

again.

Cursor Controls
Push
M
or

to put the cursor below the digit in an output
value that is to be increased or decreased.
Push

to increment the digit in the output value where the
cursor is.
Push
P
to decrement the digit in the output value where
the cursor is.
The

and
P
keys are also used to adjust LCD Contrast
level, LCD Backlight level, and Remote Interface
Configuration selections as given in “LCD and Remote
Interface Setup Procedure” in Chapter 5 of the Users
Manual.
Figure 3. Primary Input/Output Display and Controls (cont.)