Fluke Biomedical DPM1B, Руководство оператора

Страница: 4 / 24

Use the original carton and packaging material for shipment. If they are not available,
we recommend the following guide for repackaging:
 Use a double–walled carton of sufficient strength for the weight being
shipped.
 Use heavy paper or cardboard to protect all instrument surfaces. Use
nonabrasive material around all projecting parts.
 Use at least four inches of tightly packed, industry-approved, shock-
absorbent material around the instrument.
Returns for partial refund/credit:
Every product returned for refund/credit must be accompanied by a Return Material
Authorization (RMA) number, obtained from our Order Entry Group at
1-440-498-2560.
Repair and calibration:
To find the nearest service center, go to www.flukebiomedical.com/service or
In the U.S.A.:
Cleveland Calibration Lab
Tel: 1-800-850-4608 x2564
Email:
globalcal@flukebiomedical.com
Everett Calibration Lab
Tel: 1-888-99 FLUKE
(1-888-993-5853)
Email: service.status@fluke.com
In Europe, Middle East, and Africa:
Eindhoven Calibration Lab
Tel: +31-40-2675300
Email: ServiceDesk@fluke.com
In Asia:
Everett Calibration Lab
Tel: +425-446-6945
Email:
service.international@fluke.com
To ensure the accuracy of the Product is maintained at a high level,
Fluke Biomedical recommends the product be calibrated at least once every
12 months. Calibration must be done by qualified personnel. Contact your local
Fluke Biomedical representative for calibration.
Certification
This instrument was thoroughly tested and inspected. It was found to meet
Fluke Biomedical’s manufacturing specifications when it was shipped from the factory.
Calibration measurements are traceable to the National Institute of Standards and
Technology (NIST). Devices for which there are no NIST calibration standards are
measured against in-house performance standards using accepted test procedures.
WARNING
Unauthorized user modifications or application beyond the published specifications may
result in electrical shock hazards or improper operation. Fluke Biomedical will not be
responsible for any injuries sustained due to unauthorized equipment modifications.
Restrictions and Liabilities
Information in this document is subject to change and does not represent a
commitment by Fluke Biomedical. Changes made to the information in this
document will be incorporated in new editions of the publication. No responsibility
is assumed by Fluke Biomedical for the use or reliability of software or equipment
that is not supplied by Fluke Biomedical, or by its affiliated dealers.
Manufacturing Location
The DPM1B Pneumatic Transducer Tester is manufactured at Fluke Biomedical,
6920 Seaway Blvd., Everett, WA, U.S.A.