fluid-o-tech TMFE2, Инструкция по эксплуатации

Страница: 8 / 12

N
ote
: PWM frequency signal (100 to 10000 Hz) with amplitude 5V (tOFF = 0V tON = 5V), 10% to 95% duty cycles range. This signal is
interpreted as a real Analog Input (Voltage). Differences in terms of amplitude tON and, in value tOFF different from 0V, modify speed value.
N
ote
: Insertion tool is Tyco Electronics P/N 59803-1
FAULT SIGNAL
The TMFR/TSFR driver has a fault signal in OR function which
includes the alarms (Autoresettable and Permanent):
1 - Over-voltage;
2 - Under-voltage;
3
- Over-temperature (controller);
4 - Start-up;
5 - Rotor blocked;
6 – Module Fault (hardware)
7 - Over-load power;
8 - Over-current limit (50% more than the over-load power)
In the picture below there is the diagram with the electronic
characteristic of the Fault Signal. It is active when low (0V). When
the TMFR/TSFR unit runs correctly the FAULT signal is high (5V).
From µProcessor
R
2
1
JP4
+ 5 VField
FAULT
0V Field 6
From µProcessor
R
2
1
JP4
+ 5 VField
FAULT
0V Field 6
Instruction for assembly the Interface Connector MTA 100 (3-640440-7)
Centerline
of Tool (Ref)
Connector
Shoulder
(Ref)
Wire
Contact
Slotted
Blade
Lead-In
Insertion Tool
Handle (Ref)
Front Beam
Contact Slot
Receptacle Contacts
Inside Connector (Ref)