/ 13 /
INSERTING THE GRAPHICS CARD INTO THE CHASSIS
Carefully lift your graphics card with the installed water block and insert it into
your PC’s motherboard PCIexpress expansion slot. Please keep in mind that
your graphics card is heavier than before it was equipped with the water block.
You need to be very careful when handling the graphics card.
Avoid all unnecessary manipulation of the water block assembly
that might damage your card or water block.
INSTALLATION OF FITTINGS AND TUBING
STEP 1
Screw in two (2) G1/4 threaded male fittings. Attach the liquid cooling tubes
and connect the water block(s) to the cooling loop.
Do not forget to plug the remaining two openings with enclosed
EK-Plug G1/4 or its equivalent.
EK recommends using EK- fittings with all EK water blocks.
CAUTION: When using connectors other than EK-ALU fittings,
pay special attention to the length of the fittings male G1/4” thread -
5mm is the maximum G1/4” thread length allowed!
TUBING
EK-ALU FITTING
G1/4 PLUG
STEP 1
