/ 10 /
INSTALLING THE WATER BLOCK
STEP 1
PLACING THE BLOCK ON THE GRAPHICS CARD
This procedure is the same for all full-cover water blocks.
Carefully position the water block with preinstalled standoffs on the graphics
card. During this process, make sure you have aligned mounting holes of the
PCB with holes of the water block (same applies to other tops).
Pay attention not to use too much force when pressing the block
down to the PCB since chip dies are prone to cracking.
STEP 1
STEP 2
M2.5 x 4 AX1 SCREW
M2.5 PVC WASHER
For this Step, you will need:
M 2.5 PVC Washer
(5 pcs)
M2.5 x 4 AX1
(5 pcs)
Phillips Head
Screwdriver
4 mm
STEP 2
ATTACHING THE BLOCK TO THE GRAPHICS CARD
Use five (5) M2.5 X 4 AX1 screws and M2.5 PVC washers. Tighten the
screws evenly using the Phillips head screwdriver. EK recommends you
start tightening the screws around the GPU core first, and then continuing
outward to prevent the damage to the GPU.
