background image

FIS105eng REV 09/2018 Printed in USA

flowserve.com

To find your local Flowserve representative

and find out more about Flowserve Corporation, 

visit www.flowserve.com

Flowserve Corporation has established industry leadership in the design and manufacture of its products. 

When properly selected, this Flowserve product is designed to perform its intended function safely during its 

useful life. However, the purchaser or user of Flowserve products should be aware that Flowserve products 

might be used in numerous applications under a wide variety of industrial service conditions. Although 

Flowserve can provide general guidelines, it cannot provide specific data and warnings for all possible 

applications. The purchaser/user must therefore assume the ultimate responsibility for the proper sizing and 

selection, installation, operation, and maintenance of Flowserve products. The purchaser/user should read and 

understand the Installation Instructions included with the product, and train its employees and contractors 

in the safe use of Flowserve products in connection with the specific application.

While the information and specifications contained in this literature are believed to be accurate, they are 

supplied for informative purposes only and should not be considered certified or as a guarantee of satisfactory 

results by reliance thereon. Nothing contained herein is to be construed as a warranty or guarantee, express 

or implied, regarding any matter with respect to this product. Because Flowserve is continually improving and 

upgrading its product design, the specifications, dimensions and information contained herein are subject to 

change without notice. Should any question arise concerning these provisions, the purchaser/user should 

contact Flowserve Corporation at any one of its worldwide operations or offices.

©  2016 Flowserve Corporation

USA and Canada
Kalamazoo, Michigan USA
Telephone: 1 269 381 2650
Telefax: 1 269 382 8726

Europe, Middle East, Africa
Etten-Leur, the Netherlands
Telephone: 31 765 028 200
Telefax: 31 765 028 487

Asia Pacific
Singapore
Telephone: 65 6544 6800
Telefax: 65 6214 0541

Latin America
Mexico City
Telephone: 52 55 5567 7170
Telefax: 52 55 5567 4224

TO REORDER REFER TO
B/M #
F.O

.

Содержание BPO









Отзывы: