|
4
QS204215 Rev B
With EchoPod
®
connected to your computer, open the WebCal
®
* software by clicking on the WebCal
®
icon.
Follow steps 1-4 to configure the transmitter. Click “Help” in the lower right hand corner and open the help
menu of WebCal
®
for instructions on WebCal
®
. If you need additional assistance using WebCal
®
, please
contact a Flowline applications engineer at (562) 598-3015.
*For complete information on the WebCal
®
software, please refer to the WebCal
®
manual located at flowline.com/webcal-software.
CONFIGURING ECHOPOD
®
WITH WEBCAL
®
1. Output Configuration
a. Configures the relays in terms of pump/valve operations as well as high or low alarms.
b. Sets fail-safe for the relays and the sensor’s output (current, voltage or frequency).
2. Tank Shape Selection
a. Defines the shape of the tank as well as the dimensional information for the tank with
respect to the sensor’s location on the tank.
3. Tank Level Configuration
a. Enters the settings for the relay activation points as well as confirms the operational
range.
4. Write to Unit
a. Uploads the configuration into the sensor.
b. Provides a custom wiring diagram specific to the signal output and/or relay configuration.
OUTPUT CONFIGURATION
Configures the relays in terms of pump/valve operations and level alarms as well as the setting fail-safe for
relays and signal output.
