Flott BSM 150, Руководство по эксплуатации

Страница: 9 / 24

371095 D/E/F - 1.2000
8
E
5.0 Delivery, transport, handling and storage
ATTENTION! Always check delivery for completeness and damage!
The carrier (forwarder or railway) is to be informed immediately in case of transport damages.
(s. yellow leaflet)
The machine is packed on pallet, it has to be transported by lift or fork truck. The packed machines are no
staple commodities!.
- sanding machine
- one sanding belt coarse - grained
- operation instructions.
6.0 Setting up the machine
The grinding machine should be placed on a level surface and screwed with 4 screws.
Check that the belt moves freely and is not impeded in any way.
7.0 Installation
Please check whether type of current, current voltage and fusing agree with the prescribed values. There must be a
protective earth terminal. Mains fusing 10 A.
For conecting the machine we recommend the cable
No.:488761 or No.: 488762 (230V)
8.0 Belt tracking (fig.3 / 4)
When first starting the machine, the belt will not run centrally on the contact wheel. This is corrected by turning the
star knop screw (17):
Clockwise - belt moves towards the left,
Anticlockwise - belt moves towards the right.
9.0 Changing the belt TBSM 75 (fig.1 / 3)
Ensure that the machine is stopped completely!
a. Unscrew star knob (23) and clamping lever (24)
b. Remove covers (4, 6) and the fence (3, 10)
c. Slacken the belt with the star knob screw (18)
d. Replace the belt.
Attention! Take care of correct direction of rotation.
e. Tighten the belt by moving the star knob screw (18) upwards
f. Reassemble covers (4, 6), pull star knob (23) and clamping lever (24).
g. Adjust the belt with the star knob screw (17)
9.1 Changing the belt BSM 75/ 150 (fig 4)
Ensure that the machine is stopped completely!
a. Remove screw (14) and open door (1),
b. remove the spark trap (2),
c. slaken the belt by turning the clamping lever (15),
d. replace the belt,
Attention! Take care of correct direction of rotation.
e. tighten the belt by turning the star knop screw (15),
f. close the door (1), thighten the screw (14) and fit the spark trap (2),
10.0 Contact grinding TBSM 75 (fig.2)
Normal grinding, grinding against the contact wheel with removed covers (4).
In case of grinding at the grinding arm, the fence can be used as grinding base - there fore screw the fence (10) on
the holder (14). In case of contact grinding do not remove the covers (1,6)
10.1 Contact grinding BSM 75/ 150 (fig 5)
Normal grinding, grinding against the contact wheel with removed covers (10).