Flotronic F 500 series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 63 / 70

Applications
Pneumatic preset counters are used for
controlling and monitoring operating sequences
capable of being expressed as numbers in
pneumatic circuits, systems or equipment.
After the counter has counted the preset number
of pneumatic pulses, which can represent a
number of items or a number of operating
cycles, it emits a pneumatic output signal which
is used to start the next following process or
operation. The preset value can be selected
anywhere between 1 and 99999.
Connections
Pre-assembled at the Flotronic factory prior to
despatch.
Z input for count pulse
Y input for reset pulse
P air input
A
output signal (set time has elapsed)
Operation
Each digit of the preset count figure can be set
independently.
Setting of adding predetermining counters
Push white lever as shown by the arrow and hold
it. Set the desired figures with the corresponding
keys. Release white lever.
61
Count & Stop Pumps
All Series
Section 19 - Count & Stop Pumps - All Series
All FPL pumps can be fitted with Count and Stop devices, which are normally mounted into a control
panel attached to the air valve assembly.
The counter used is of proprietary manufacture.
FPL reserve the right to provide alternative types of Count and Stop Devices of similar but not necessarily
the same operation.
Units can be remote mounted if required contact FPL for maximum remote connections.
actual value
pre-set value
Pre-set
pushbuttons
Setting of subtracting predetermining counters
Press reset button and at the same time enter the
desired preset figure by means of the preset keys.
INDICATION
Medium: Filtered compressed air, with no oil.
Working pressure: 2 to 8 bar.