4 GB
Installation
j
Choose a part of the wall surface with approx.
50 cm free to each side so that the hose reel
can be turned through 180°.
j
If you wish to take the hose around a wall corner,
mount the hose reel at least 1 m from the
corner and use a hose guide (not included).
Note:
To prevent backflow do not install the hose
reel higher than the tap.
Or: Install a reflux preventer or a pipe interrupter
between tap and hose.
Q
Mounting the wall holder
Important!
The holder must be mounted
vertically (see Fig. A).
j
Use the four screws and dowels supplied. They
are suitable for mounting on brick, concrete or
wooden walls only. For mounting on other ma-
terials please use suitable screws and dowels.
Enquire in your local DIY shop for some suitable
screws and dowels for your particular wall.
Q
Mounting the hose reel
j
Push the hose reel
2
on to the wall holder
1
and fix it with the enclosed securing pin
11
(see Figs. B).
j
Attach the tap attachment
5
to the free end of
the hosepipe attachment
4
and screw it on to
the water hosepipe connector
6
(see Fig. D).
j
Push the hosepipe connector with water stop
function
10
and the spray nozzle
9
on to the
long garden hose.
j
Check that the hose reel
2
can turn through
180° (see Fig. D).
j
Before first use turn the tap on and allow water
to run through the garden hose.
j
Check the device for leaks and tighten any
loose connections if necessary.
Q
Using the hose reel
j
Hold the end of the hose firmly when unwinding
the hose and pull the hose out of the hose reel
2
.
j
The hose reel
2
has an automatic stop
function which ensures that the hose is kept at
the desired unwound length. As the hose is
unwound a click sounds from the stop function
every metre. When the desired length has been
unwound, pull out the hose carefully a little fur-
ther until the next click sounds. The hose is then
fixed at the desired unwound length and can
be placed on the ground without it springing
back into the housing by itself.
j
If you wish to unwind more of the hose, hold
the hose firmly and proceed as described above.
j
The automatic stop function is cancelled by
pulling the hose quickly past the next click and
then guiding the hose back carefully by hand
into the hose reel
2
.
j
You can regulate the water jet by turning the
spray nozzle
9
.
Note:
j
Reduce the pressure if the hose cannot be
properly guided into the housing with the tap
turned on. Either allow some water to flow out
of the hose or turn the water off.
j
If the hose does not wind back on to the reel
return under its own power, hold it slightly
above hip-height and guide it carefully back
onto the reel.
Q
Using the spray nozzles
j
Attach the spray nozzle
9
onto the hosepipe
connector with water stop function
10
.
j
To adjust the water discharge, turn the front
part of the spray nozzle. The spray nozzle can
be used to interrupt the discharge of water. The
connector with the water-stop function interrupts
the water flow when the nozzle is removed
from the turned-on tap. Only use these two
functions for intermittent interruptions of the flow
of water. Never leave the hose unsupervised in
such instances.
106624_flo_Schlauchaufroller_content_HU_SI_CZ_SK.indd 4
24.10.14 13:30
