Floe 500-95500-00, Руководство пользователя

Страница: 12 / 40

Page 12
Safety
Securing The Load
Safety
Trailer Lighting System
Special emphasis has been placed on the design of
your FLOE trailer’s lighting and wiring system to
ensure that it is long-lasting and maintenance-free.
FLOE uses high quality lights that are commonly
found on commercial over-the-road trailers.
SIDE MARKER LIGHTS (Amber and Red)
• Shock-mounted (on replaceable rubber
grommets)
• Waterproof sealed units (for longer life)
• Easy to replace
• Small enough to carry spares
REAR TAIL/BRAKE/TURN SIGNAL LIGHTS
• Standard size
• Easy to replace and to carry spares
REAR ID MARKER LIGHTS, FRONT/REAR
CLEARANCE LIGHTS
• Standard size
• Easy to replace and to carry spares
TONGUE CONNECTOR AND HARNESS
• Electrical connector has a molded harness for
long lasting durability. Your trailer is equipped
with a plug-in receptacle to keep the electrical
connector protected when not in use.
• Tongue portion of wiring harness can be replaced
without having to splice or replace the remaining
wiring harness.
• Wire harness is run through the trailer frame to
keep it protected from the elements.
• To ensure trouble-free use, periodically inspect
all connections for tight, corrosion-free contact
and apply an electrical grease as necessary to
prevent future corrosion.
The wiring diagram provides the information
needed for wiring the towing vehicle harness/
connector. It is important that the proper
connections be made and that the system is tested
before using your trailer.
White - Grounds all lights
Brown - Front & rear marker lights
3 light ID bar & tail lights
Yellow - Left turn / brakes
Green - Right turn / brakes
QUICk-LOOP™ INSTALLATION
Lubricate the threads of the bolt with Anti-seize.
Insert the Quick Looop assembly into the Versa-Track. Rotate
the cam until the insert catches in the Versa-Track. While
pulling up on the Quick Loop, tighten until insert stays engaged
with slot. Slide the Quick Loop to the desired location and
finish tightening the bolt. Quick Loops should be installed so
that the pull is as close to perpendicular as possible.