FLIR mariner, Руководство оператора

Страница: 16 / 48

3 – Getting Started
10 11/06 427-0010-00-10, version 120
Step 2 Route power leads from the 12VDC power source in the fuse
protected main electrical panel to the control. Wire must be 16
gage with a maximum run of 100 feet.
Step 3 Crimp the terminals supplied onto the power leads. The larger
terminal is crimped to the positive lead, the smaller to the
negative. The terminals are clearly marked.
Step 4 Insert the wiring cable and power leads through the hole and plug
them into the control unit.
Step 5 Use bedding compound or sealant to waterproof the control
mounting.
Step 6 Secure the control with the self-tapping screws provided.
Step 7 Two 2 Ampere automotive type fuses are included in the control
unit as shown in Figure 3-6. The fuse on the left protects the
camera; the right fuse protects the pan-tilt motor circuit. See the
troubleshooting section of this User’s Guide for instructions on
replacing the fuses.
Figure 3-5: Joystick Control Unit Mounting Template
Figure 3-6: Joystick Control Unit
2 Amp fuses