FLIR M-Series, Руководство оператора

Страница: 19 / 64

432-0003-00-10 rev 140 M-Series Operator’s Manual 21
System Startup
moves to the Stow position in order to provide additional protection for the
camera optics.
Camera Discovery
If the Power/Dim button is pressed after the system bootup is complete,
the JCU will automatically detect all available cameras on the network. The
first time a camera is started, the installer must associate the JCU with the
camera. The display on the JCU will indicate “
Select Camera
” the first time
a JCU connects to a camera. Scroll down to the available camera and press
(or “click") the puck to accept the camera shown in the JCU Display. The
JCU will automatically connect to the last camera it was linked to after the
initial startup.
Troubleshooting Tip : if the JCU does not discover any cameras, check to
make sure the JCU and the camera are connected to each other over the
network or directly with a single cable.
If the Power/Dim button is pressed while the camera is booting up, the JCU
LCD display will say "Searching..." until the JCU discovers cameras on the
network. If there are multiple cameras in the network, the JCU will discover
them and the user must select one. The user can move the puck fore and
aft to scroll through the list of discovered cameras. Once a camera has
been selected, the next time the user powers the JCU, the JCU will default
to the last camera it was connected to.
Note : In the JCU Display, a down arrow (V) indicates additional menu
choices can be accessed by moving the puck down (aft), or by rotating the
puck clockwise. An up arrow (^) indicates the last menu entry is shown in
the display, and the other choices must be accessed by moving the puck up
(fore) or by rotating the puck counterclockwise. A double arrow indicates the
user can move up or down in the menu.
Standby Mode
After the bootup sequence, the camera will switch from the Bootup mode to
the Standby mode. In the Standby mode the pan/tilt motors are engaged in
high-power mode, to hold the camera in place in rough seas. In the Standby
mode, the cameras will not supply a live video signal via the video cables.
The gimbal assembly does not respond to any commands or buttons from
the JCU (with the exception of the Power/DIM button). The camera ball will
be pointing straight down, to protect the camera optics.
1 Refer to the Troubleshooting Tips section in the System Operation and Configura-
tion chapter for more information about messages that appear on the video
screen.
Note: When a dual payload
camera powers up, it will display
the IR video on both channels
initially. Then the IR/VIS video
channel will switch to the visible
camera if the visible camera
was selected when the camera
was last powered down.