FLIR Lepton 1.5, Инженерная спецификация

Страница: 43 / 84

FLIR LEPTON® Engineering Datasheet
The information contained herein does not contain technology as defined by the EAR, 15 CFR 772, is publicly available,
and therefore, not subject to EAR. NSR (6/14/2018).
Information on this page is subject to change without notice.
Lepton Engineering Datasheet, Document Number: 500-0659-00-09 Rev: 203
43
Parameter
Power-On
Default
Section in this document
SYS Scene Stats ROI
12
(startCol, startRow, endCol, endRow)
(0,0,79,59) or
(0,0,159,119)
SYS FFC Mode Auto FFC States , page 18
SYS FFC Period 180000 FFC States , page 18
SYS FFC Temp Delta 150 FFC States , page 18
SYS Gain Mode High Gain States , page Gain States 22
VID Color LUT Select Fusion Video Output Format Modes , page 36
OEM Video Output Format Raw14 Video Output Format Modes , page 36
OEM GPIO Mode Disabled GPIO Modes , page 39
OEM GPIO VSYNC Phase
Delay 0 lines Frame Synchronization , page 53
RAD Radiometry Control Enabled Radiometry Modes , page 29
RAD TLinear Enable State Enabled Radiometry Modes , page 29
RAD TLinear Resolution 0.01 Radiometry Modes , page 29
RAD Spotmeter ROI
(startCol, startRow, endCol, endRow)
(29,39,30,40) or
(59,79,60,80) Radiometry Modes , page 29
RAD Flux Linear Parameters (8192, 29515,
8192, 29515,
8192, 29515, 0,
29515)
Radiometry Modes , page 29
This feature is intended to be performed at the OEM’s factory, because it requires an additional voltage supply
and pin connection that should not be connected in run-time operation. The Lepton module pin connection for
the programming voltage is described in
Table 8
below, and the electrical specifications for the supply are
defined in
Table 9
below.