FLIR gS125 inverted, Руководство по установке

Страница: 52 / 102

Connecting the data cable
Follow the steps below to connect your HD-SDI data
cable to the multifunction display.
1
3
2
4
D13048-3
1. Ensure the BNC connector is correctly orientated.
2. Fully insert the BNC connector into the relevant
HD-SDI connection on the back of your
multifunction display and turn the locking collar
clockwise until locked into position.
3. Push the protective boot over the BNC connector
and HD-SDI connection on the back of the
display.
4. Use 2 cable ties (supplied) to secure the
protective boot over the connection.
Protecting disconnected cables
If a BNC cable is to be left disconnected then the
protective cap should be secured to the end of the
boot.
1 2 3
D13050-1
1. Disconnected the BNC cable from the
multifunction display.
2. Push the boot over the cap as shown below.
3. It is recommended that a cable tie be used to
secure the boot to the cap.
HD-SDI maximum cable length
The maximum recommended cable length is shown
below.
HD-SDI input cable 50 m (164 ft.)
4.25 Thermal camera connection
Thermal cameras can be connected directly to the
display’s network connection or can be connected to
the
SeaTalk hs network, via a Raymarine ® network
switch.
2 connections are required:
• Network connection — required to control the
thermal camera via a compatible Raymarine ®
MFD or optional Joystick Control Unit (JCU).
• Video connection — transmits the composite
video signal to a compatible Raymarine ® MFD .
Note: The Thermal camera can only be connected
to MFD s with a Video input connection.
T200 Series connection
D12839-2
3
2
1
4 5 6
7
1. MFD
2. Thermal camera
3. Power over Ethernet (PoE) Injector
4. RayNet to RJ45 SeaTalk hs adaptor cable
5. Network connection to MFD ( RayNet )
6. Video connection to MFD (composite video)
7. Video cable
T300 / T400 Series connection.
SeaTalk
hs
/ RayNet
SeaTalk
hs
/ RayNet
SeaTalk
hs
/ RayNet
D12260-2
6
7
4
9
3 2
1
5
8
1 0
1. MFD
2. Video connection to MFD (composite video)
3. Network connection to MFD ( RayNet cable)
52
gS Series installation instructions