FLIR FC-Series ID, Руководство по установке

Страница: 8 / 60

427-0089-00-12 Version 100 July 2016 8
1 Camera Installation
•
PoE+ power supply or PoE+ switch, if used for system power. Note that the
camera will operate
normally with PoE, but lens heaters may not operate to specification in cold environments.
• Cat5e or Cat6 Ethernet cable for digital video and/or PoE+ for system power
• Coaxial RG59U cables (BNC connector at the camera end) for analog video
• Camera grounding strap, camera mount, electrical hardware, connectors, and tools
Be sure to use cables that fit in the cable gland holes, as described below. Refer to
Rear Access
Cable Gland Sealing, pg. 15
for more information.
1.3.5 Camera Mounting for Rear Cable Access
The FC-Series ID camera can be secured to the mount with two in-line 1/4-20 threaded fasteners on
the top or bottom of the camera. Alternatively the camera can be mounted with four M5 x 0.8
threaded fasteners to the bottom of the camera. Use Loctite 222 low strength threadlocker for the top
mount fasteners (can be used with the bottom mount fasteners also). Refer to the FC-Series ID ICD
for additional information.
If using two 1/4-20 fasteners in the center of base, the maximum depth of the fastener should not
exceed 12.5 mm (0.5 in). If using four M5 x 0.8 fasteners, the maximum depth of the fastener should
not exceed 10.0 mm (0.4 in).
Figure 1-1: FC-Series ID Camera Bottom Mounting Holes