FLIR FC-Series ID, Руководство по установке

Страница: 23 / 60

427-0089-00-12 Version 100 July 2016 23
2 Basic Operation and Configuration
2.3 Camera Bench Test
The camera offers both analog video and IP video, and since the camera can be powered by PoE+ or
by a conventional power supply, there are several ways to bench test the camera. It is recommended
that the installer test the camera using the same type of connections as in the final installation.
Even if using analog video and conventional power in the final installation, it is a good idea to test the
IP communications when performing the bench test. If any image adjustments are necessary, they
can be done using a web browser over the IP connection, and saved as power-on default settings.
With the camera powered up, analog video can be tested at the BNC connector. Connect the camera
to a video monitor and confirm the live video is displayed on the monitor.
If using a conventional power supply, connect the camera to a network switch with an Ethernet cable,
and connect a PC or laptop to the switch also. Use a web browser to access and test the camera as
described below, and if necessary make configuration changes prior to installation.
2.3.1 Log in to the Camera Web Page
With a web browser, log in to the camera using one of three User Names:
user
,
expert
, and
admin
.
By default, the passwords are:
user
,
expert
, and
fliradmin
, respectively. The login passwords
should be changed to prevent unauthorized log ins (refer to
Basic Camera Configuration, pg. 26
).
Open a web browser and enter the camera’s IP address. The login screen with a picture of the
camera will appear. A pull-down list in the upper right allows the user to select a language option.
Enter
user
for the User Name and
user
for the Password, and click Log in.
The
user
login can be used to do the initial bench test of the camera. The
expert
login can be used
to make basic configuration changes such as setting the IP address. The
admin
login is used for
more advanced configuration changes, and is described in
Advanced Configuration, pg. 38
.
Note
Two web sessions can be active at once. An inactive session will be logged out after 20 minutes.
Figure 2-1: Camera Web Page Login Screen