Elara FR-345-EST QIG Rev 110
December 2020
This document does not contain any export-controlled information.
In the
DNA - IP Setup
window, clear
Use DHCP
and specify the camera's
IP
address
. You can also specify the
Mask
(default: 255.255.255.0) and
Gateway
.
Then, click
Update
, wait for
Ok
status to appear, and then click
Close
.
4 Install the Camera
The camera can be mounted directly on a wall or a ceiling, or it can be mounted
using the CB-WLBX-G4 Wall & Surface Mount Kit, which includes a junction box.
For the full list of mounting and other accessories available for the camera, see the
FLIR Security Cameras - Accessory Guide
.
4.1 Fit Mounting Hardware
If using the CB-WLBX-G4 Wall & Surface Mount Kit with junction box, install it
according to the installation guide for that accessory.
If using other mounting hardware, install the mounting hardware for the camera
according to instructions.
4.2 Prepare the Surface for Mounting
Be sure to have the required accessories
and tools available.
Refer to the camera's installation and
user guide as necessary.
a. Attach the mounting template sticker
onto the wall or ceiling where you are
mounting the camera.
b. Drill six anchor holes according to the
template.
c. Hammer the six plastic anchors into
the drilled holes.
d. If the system cable is going to exit
from the rear, drill a hole in the center
of the mounting template for the
cable.
The system cable can exit either from
the side of the camera's mounting
bracket or through the hole in the
back of the mounting bracket.
Side cable exit
