FLIR DM284, Быстрый старт

Страница: 3 / 10

FLIR DM284 – DMM QUICK START GUIDE Document Identifier: DM284-QS_DMM-en-US_AC
FUNCTION BUTTONS
Use to select a sub-function of the primary function.
From Auto range mode, press to select Manual range mode.
From Manual range mode, short press to change the range. Long press to activate Auto range mode
Press to activate the Thermal Camera IGM
TM
(Infrared Guide Measurement).
Use the selector/navigation pad to navigate mode and advanced function menus.
Press to cancel/exit a screen in the Settings menu (no function in the normal mode).
Press to enter Hold mode (display hold or auto hold as selected in the Multimeter Settings Menu).
Press to enable/disable the work light.
DISPLAY SYMBOLS
Low Impedance mode Auto power off function enabled
Measured voltage is > 30 VAC/DC AC current or voltage
Non-Contact Voltage detector DC current or voltage
Battery voltage status Flex Clamp Direct Input
MAX (Maximum) reading Continuity function
MIN (Minimum) reading Diode test function
AVG (Average) reading VFD mode
PEAK MAX value displayed
P
Peak mode
PEAK MIN value displayed
H
z
Frequency mode (ACA/ACV)
Auto range mode Relative mode
Data Hold mode Work light active
0000
Primary display (large digits)
Bar Graph Display
0000
Secondary display (smaller digits)