Make pilot holes for Keyboard
Tray (FIK) or Pull Handle (FIH)
• Turn the table top over to work on the
underside
• If you are installing the FIK-19 or FIK-23, use
the same template used for making the top
cut-out.
• Align the template to the Center Line of the
user side. You will also be able to reference
the actual cut-out to assure alignment.
• Use a 1/8” drill bit to
scribe the placement
of the pilot holes
• Note that the choice of
flange in or flange out is
possible to accommodate
the tight placement of other
fixtures or base
cabinet restrictions.
• If you need to change your
mind about which to use,
scribe all of the pilot holes.
• To finish the pilot holes,
remove the paper
template, use a depth gauge
on the drill bit, and make
3/8” deep holes.
• Take care to not drill com-
pletely through your table
top and ruin the surface!
• The FIH section of the template is
used to mount the PULL Handle on
the user’s right, referenced from the
CenterLine and user edge.
• Scribe the position with the 1/8” drill
bit, remove the template and finish
the pilot holes with a depth gauge.
Make a
depth gauge
using tape
if you don’t
have a metal
one with a
set screw.
7
