Cables should be attached loosely
The cable on the flipIT cable arm assembly ships attached, but
if it should need adjustment, do not overtighten the cable. It
needs to work freely. Adjust it with a 3/8” open end wrench
and #2 Phillips blade screwdriver.
FIH Models
Attaching
cable arm to
PULL handle
• Thread the cable to
the set of holes that
line up with the FIH-
19 or FIH-23 model.
• FIH-19 inside hole set
• FIH-23 outside hole
set
• Install the self-
tapping metal screw
into the middle hole
• Tension the cable so
it is a straight line, but
not as tight as a guitar
string. If the cable is
over-stretched the lid
will not close flush.
• Too much slack, and
the tipping point may
not be reached for
opening.
• Fully tighten the
screw to hold the
cable in place:
#2 Phillips blade.
10
technical support 800-770-7042
www.smartdesks.com
Inside Hole Set
for FIH-19
Outside Hole Set
for FIH-23
