FLEXO Trim FEM 1200, Руководство по эксплуатации

Страница: 20 / 66

GB-6
Troubleshooting
Fault Possible cause Rectification
The motor cannot be No power Check mains supply.
started. Cable damaged Check cable, pull the plug and insert again,
if required, replace the cable or have it
repaired by a qualified electrician
Safety switch/plug combination Have the tool repaired by a specialist
damaged
workshop.
Overheating protection is activated 1. Working depth too deep, continue work with
less working depth
2. Tines are blocked, remove blocking.
3. Soil is too hard, adapt working depth
accordingly and work soil by repeatedly
moving forward and backward over
the same place.
Let the motor cool down for about 15 minutes
before you resume your work.
Unusual Tines are blocked Switch the tool off, wait until the motor fully
sounds stops. Eliminate the cause of the blockage.
Lubricating agent is leaking Have the tool repaired by a specialist
workshop.
Screws, nuts or other fastening Fasten all elements; if the sounds remain
elements are loose contact a specialist workshop.
Unusually strong Tines are damaged or worn out Replace the tines or have them checked by a
vibration specialist workshop.
Working depth too deep. Adjust working depth to a suitable depth.
Bad tilling result Working depth too low. Adjust working depth to a suitable depth.
Worn-out/blunt tines. Replace the tines or have them checked by a
specialist workshop.