Operators and Reference Manual
MC12
MC12 OM RM EN 74-111-132 v1.03.doc
Ver. 1.03
Page 11 of 47
6.3 Parameters
In the following a parameter will be a single value like for example volume, velocity, number
of fillings etc.
6.4 Programs
In the following a program will be a complete set of parameters which together form a
program according to which MC12 and the connected pump will operate.
6.5 General information on the programming of MC12
MC12 is equipped with a battery in the memory and will therefore always remember the
programmed parameters, even if the main switch is turned off.
The programming is made via functions, i.e. every operating parameter has its own function
number.
The programming is made by entering the function number followed by "ENT".
This will make the required function appear in the prompt line of the display and show the
current value or information of the function.
This value will automatically be overwritten when entering the new value. After being entered,
the new value will be displayed in the prompt line. The new value is entered into the
computer by pressing "ENT".
The new value will be displayed in the status lines at once.
Example:
If a volume of 8.5 ml is required, the following should be entered:
<1>+<ENT>+<8>+<.>+<5>+<ENT>
MC12 knows automatically which filler is connected. Consequently, values which are not
valid for this pump will not be accepted.
If a faulty value is entered, it will not be entered, and a "beep" sound will be heard.
