REV.000
705 Commerce Drive, Wapakoneta, OH 45895 | www.flexmachinetools.com | 1-800-837-2503
1. The rotational gimbal should come attached to the arm as shown below on the left, if the tool has been
provided to FlexArm it will come already mounted.
2. The first thing to do is remove the air handle from the grinder by removing the housing bolts. Keep the
rubber seal attached to the handle. FlexArm will provide an additional seal to connect between the gimbal
sleeve and the tool’s housing.
ATTACHING AN HORIZONTAL GRINDER (101100-101400)
3. Then insert the housing bolts through the air handle and the gimbal
sleeve as shown in the image above and tighten the bolts securely into
the tool’s housing.
4. Lastly, attach the gimbal clamps around the gimbal sleeve and tighten
the clamp bolts securely.
5 of 12
B-19 WITH ROTATIONAL GIMBAL
Rev.000
ATTACHING A HORIZONTAL GRINDER (101500)
1.
The rotational gimbal should come attached to the arm as shown below on the left, if the tool has been
provided to FlexArm it will come already mounted.
2.
The first thing to do is remove the air handle from the grinder by removing the housing bolts. Keep the
rubber seal attached to the handle. FlexArm will provide an additional seal to connect between the
gimbal sleeve and the tool’s housing.
3.
Then insert the housing bolts through the air handle and the gimbal sleeve as shown in the image
above and tighten the bolts securely into the tool’s housing.
4.
Lastly, attach the gimbal clamps around the gimbal sleeve and tighten the clamp bolts securely.
Note: Each tool varies, please contact a FlexArm specialist with any questions.
5 of 12
B-19 WITH ROTATIONAL GIMBAL
Rev.000
ATTACHING A HORIZONTAL GRINDER (101500)
1.
The rotational gimbal should come attached to the arm as shown below on the left, if the tool has been
provided to FlexArm it will come already mounted.
2.
The first thing to do is remove the air handle from the grinder by removing the housing bolts. Keep the
rubber seal attached to the handle. FlexArm will provide an additional seal to connect between the
gimbal sleeve and the tool’s housing.
3.
Then insert the housing bolts through the air handle and the gimbal sleeve as shown in the image
above and tighten the bolts securely into the tool’s housing.
4.
Lastly, attach the gimbal clamps around the gimbal sleeve and tighten the clamp bolts securely.
Note: Each tool varies, please contact a FlexArm specialist with any questions.
Note: Each tool varies, please contact a FlexArm specialist with any questions.
