Press
the key number
9
The
Point Nr. 9
will then spring from
”straight“ to ”curved“. Pressing the number 9
again will set the point back to ”straight“
again.
You can use the same procedure for all the
other points. Simply put in the point number
(1-0) in via the keyboard and the relevant
point will be changed in the display.
Important:
Important:
In order to
change
points with
numbers other than 9 -12, the MA decoder
6852 must be reprogrammed. You can find
out how this is done in the later chapter
”Expert Knowledge“
.
We will now show you just one example
(without a real layout) as
a practice
.
On a large layout, let us assume that if a loco
with address 3 (we will show you how to alter
the address in
”Expert Knowledge“
) is runn-
ing forwards at speed level 17, and the points
9, 10, 11 and 15 need to be set to ”curved“.
19
With the key (=downwards) you can go
back down each batch of ten to the (pre-
vious) point batch, here numbers 1 - 10.
Using the (=MADR) you will access the
”
mag
netically operated article
add
ress“.
Info:
The electrical accessory receiver mod-
ule 6852 has the
address ”3“
preset as the
factory setting. At the same time, its 4 out-
puts recognise the magnetic article address-
es internally as
9
to
12
. (How to alter the
addresses of the receiver modules is shown
in the later chapter marked
”Expert Know-
ledge“
).
As we have connected the points onto out-
puts 1 and 2, and the uncouplers onto 3 and
4, then the points will be shown in the display
as
Nr. 9
and
Nr.10
.
Inputting one point number via the keyboard
will show at a glance the actual positional
setting of this point (straight or curved).
For point numbers
higher than 10
: Using the
keyboard, just press the ”single number“, i.e. for
11, the ”1“, for 37 the “7“ and so on.
18
Initial Knowledge
Initial Knowledge
