Flavor Burst CTP 80CBB, Оборудование, техническое обслуживание и эксплуатация: Руководство

Страница: 56 / 80

55
5. Clean, rinse and dry the area of the freezer
to which the switch or bracket will be
attached using detergent, water, and single
service towels.
6. Remove the other side of the protective
backing from the adhesive strip and attach
the switch or bracket assembly to the
appropriate position on the freezer.
7. Connect one end of the switch extension to
the ELE 510 switch port. Connect the other
end of the extension to “PORT 1” on the
underside of the Touch Panel. Ensure the
connections are fully engaged.
NOTE: WHILE “PORT 2” IS ALSO A VALID
SWITCH PORT, IT IS TEMPORARILY
PLUGGED TO AVOID CONFUSION. YOU
WILL ACTIVATE THE PORT YOU USE WHEN
YOU GO THROUGH THE EQUIPMENT
SETUP WIZARD PROGRAM ON YOUR
COLOR TOUCH PANEL LATER.
NOTE: CABLE CLIPS MAY BE USED TO
SECURE THESE CABLES SO THAT THEY
DO NOT INTERFERE WITH THE OPERATING
PARTS ON THE FRONT OF THE FREEZER.
Installing the ELE 510 Draw Switch
Internally on a Taylor 428 / 432 Freezer
Flavor Burst highly recommends integrated
switches be installed to power the
CTP 80CBB system.
However, if no integrated
switches are available at the time of installation,
use the ELE 510 external switch included with
this system. The ELE 510 can also be mounted
inside the front panel of Taylor 428 and 432
models as directed below. Alternately, you can
use an ELE 518 internal switch kit for slush
product or an ELE 526 internal switch for shake
product on these freezers, however they are not
included with this system. Contact your
distributor for more information.
NOTE: ENSURE THE FREEZER IS TURNED
OFF AN UNPLUGGED TO AVOID ANY
ELECTRICAL SHOCK WHEN WORKING
WITHIN THE TAYLOR 428 / 432 PANEL BOX.
1. Unscrew and remove the front panel from
the Taylor 428 or 432 freezer.
2. Attach one small square pieces of adhesive
to front bottom of the flat bracket piece that
comes with the ELE 510 switch. Attach
another piece of adhesive to the upper end
of the bracket on the other side. Then,
attach the switch behind that upper
adhesive piece as shown, with the switch
lever pointing to the right.
26155
26093