Operation and installation manual
Operation and installation manual
DISHWASHERS
21
DRAIN HOSE CONNECTION
Insert the drain hose into a drain open-
ing, minimum diameter 4 cm, check, if
there are any bends. As it may be required,
use a special fastener, which is included
(Fig. 6). The free end of the hose may be
positioned at a height ranging from 40 cm
to 1 m. Do not dip it into water.
ATTENTION!
Be sure to properly fix the plastic fas-
tener because the hose mustn’t be
loose. Failing to do this may result in
water splashing.
Figure 6. Drain hose connection.
ELECTRICAL CONNECTIONS
ATTENTION!
NEVER USE EXTENION CABLES AND
CONNECTING ADAPTERS FOR THIS
APPLIANCE! UNDER NO CIRCUM-
STANCES DISCONNECT THE GROUND
PLUG FROM THE WIRE.
Requirements
for electrical connections
Please, look through the table to con-
tain power values to find out the voltage and
connect your dishwasher to a power supply
source. Use a 15 A fuse. Use copper wires
only! It is recommended to use a time-delay
fuse and circuit breaker.
The socket must be close to the appliance.
ATTENTION!
Check the earthing before use.
Make sure that the mains voltage value
conforms to that one in the manufacturer’s
plate. Plug in (the socket must be grounded,
too). If the socket doesn’t suit for the plug,
you better replace the socket other than use
any connecting adapters, because these
may overheat and burn.
U-JOINT CONNECTION
How to connect a U-joint
There is a new U-joint to be used to connect
the appliance to a water supply source.
Water pressure values may range from 0.04
to 1 MPa. If the water pressure is below a
minimum value, contact a representative of
your service center.
1. Pull the U-joint and all its hoses from
the compartment on the rear wall of the
dishwasher.
2. Attach the U-joint to the water cock, us-
ing ¾’’ screws.
3. Turn the water cock all the way to open
it before starting the dishwasher.
