- 27 -
In order to work better and maintain the power of the welder, please must
observe the following regulations:
If the power source of the welder is placed on an inclined plane, attention should be paid to
preventing it from falling.
It is forbidden to use welding power for the thawing of pipes.
When the welding power source is lifted using a forklift, it should be mounted sideways to
prevent tipping.
When the welding power supply is lifted by a crane, the cable should be tied at the lifting ring.
The angle between the cable and the vertical should not exceed 15 degrees.
When the welder is equipped with gas cylinders and wire feeders, these two devices should be
taken from the power supply and the welder level should be kept as far as possible. When
moving the gas shielded welding machine on the ground, be sure to When the welding power
supply is lifted by lifting fork lift, to prevent dumping, please install from side.
When the welding power supply is hoisted, the cable shall be attached to the hanging ring, and
the Angle between the cable and the vertical direction shall not exceed 15 degrees.
When the welding machine is equipped with gas cylinder and wire feeder, the two devices
should be connected to the power supply and the welding machine level is maintained as far as
possible. When moving the gas shielded welding machine on the ground, be sure to fix the
cylinder with a belt or chain to prevent the dumping.
If the wire feeding machine is used for welding, make sure it is firm and insulated.
。
If the device has a strap or handle, remember that it is only suitable for hand use. It is
prohibited to use crane, forklift or other mechanical hoisting.
Attention to electromagnetic interference
Additional precautions may be required when welding power is used in a local area.
Before installing the welding equipment, the user should assess the potential electromagnetic
problems in the installation environment area, as shown below:
a) The upper, lower and adjacent power cables, control cables, signal cables and telephone
cables of the welding equipment;
b) Radio and television transmitting and receiving devices;
c) Computer and other control equipment;
d) Safety identification equipment, such as the monitoring of industrial equipment
e) People Health conditions such as cardiac pacemakers and hearing AIDS;
f)
Equipment used for calibration and measurement;
g) Interference of other equipment in the environment; Users shall ensure that other
equipment in the environment is compatible with the environment; This may require
additional protection;
h) The actual situation of welding or other activities carried out.
Users should comply with the following items to reduce radiation interference:
Содержание FM 155E
Страница 1: ...1 Operation Manual FM155E MIG Welding Machine...
Страница 9: ...9...